Custom food jars for brands | ZILOOP

Capacity and mouth diameter decide use

Capacity Mouth Typical use
400–600 ml 70–80 mm Soup, porridge, single serving
700–900 ml 80–90 mm Meals, two compartments
1,000 ml+ 90 mm+ Family, bulk

A wide mouth is easier to fill and clean but loses heat faster; narrow mouths retain better and are harder to clean.

Sealing is the failure point

Food jars fail at the gasket, not the vacuum. Specify the gasket material (silicone, food-grade), the compression set it must survive, and the number of open/close cycles you expect.

Ask for: 30-minute inversion test with hot contents, and a microwave-safety statement if the buyer intends to reheat (most stainless jars are not microwave safe — state it on the packaging).

Food-contact documentation

Buyers in the EU and US need documentation that the food-contact surface meets the destination market's requirement. The documents are issued for the specific material and sample; request them for the model you are ordering rather than assuming category coverage.

MOQ and timing

Scope Minimum Planning lead time
Existing jar, logo 200 pcs 25–30 days
Custom colour + insert 500 pcs 30 days
New lid or compartment 1,000 pcs tooling in writing

Related: food jars, 12-18oz food jar.