Vacuum insulated drinkware manufacturing | ZILOOP
From coil to carton: six stages
| Stage | What happens | Where it fails |
|---|---|---|
| 1. Forming | Stainless coil is drawn into inner and outer bodies | Wall thickness variation |
| 2. Welding | Bottom and seam welded; neck ring attached | Weld porosity |
| 3. Vacuum | Air evacuated between walls, then sealed | Seal integrity, vacuum level |
| 4. Finishing | Polishing, powder coating, printing | Coating adhesion |
| 5. Assembly | Lid, gasket, straw, base sleeve fitted | Gasket fit |
| 6. Inspection | Leak, insulation and visual checks | Sampling discipline |
Stage 3 is the one buyers underestimate
The vacuum is pulled through a small port and sealed. If the seal is imperfect, the bottle loses insulation gradually rather than failing immediately — which is why a one-day sample test can pass while the production lot underperforms three months later.
Ask for the vacuum level at sealing and a leak-decay check as part of the production record, not only the sample.
What you can control as a buyer
- Wall thickness — affects both insulation and weight
- Lid insulation — most heat escapes through the lid
- Finish — textured coatings hide handling marks better than gloss
- Inspection standard — agree on AQL level and the defect list before production
MOQ and timing
| Scope | Minimum | Planning lead time |
|---|---|---|
| Existing model, logo | 200 pcs | 25–30 days |
| New finish | 500 pcs | 30 days |
| New structure | 1,000 pcs | tooling schedule in writing |
Related: water bottles, 40oz tumblers.
---