Drinkware vacuum insulation quality checks | ZILOOP
Kwaliteitscontroles op vacuüm-isolatie
Vacuüm-isolatie is onzichtbaar tot het faalt, vaak weken later. De gids legt uit waar het misgaat (poortafsluiting, lasnaad, restvocht, coatingwarmte) en welke tests dat aantonen: retentie over 48–96 uur, 100% IR-thermografie, kantel- en lektest. Belangrijk: testen ná de coating, niet alleen ervoor. Ook staat erin welke gegevens een bruikbaar testrapport moet bevatten.
De volledige gids is beschikbaar in het Engels.
What "vacuum insulated" actually means
Two stainless walls, the air between them evacuated, and the gap sealed. Performance depends on three variables: the vacuum level achieved, the wall thickness, and the lid.
A poor lid can waste a good vacuum: most heat loss on a tumbler happens through the lid, not the body.
The two tests that matter
| Test | Protocol | What it proves |
|---|---|---|
| Hot retention | Fill with water at a stated temperature, measure after N hours | Body insulation |
| Cold retention | Fill with iced water, measure ice remaining / temperature after N hours | Combined body + lid |
Ask for the protocol, not just the number. "12 hours hot" means nothing without the starting temperature, the fill level, the ambient temperature and the lid used.
Reading a test report
- Which model and which lid was tested
- Starting temperature and fill volume
- Ambient conditions
- Measurement points and method
- Whether the sample was production or a hand-built prototype
A report without these five items cannot be compared with another supplier's.
Vacuum integrity checks
| Check | Method | Failure sign |
|---|---|---|
| Vacuum level | Gauge on the pump line | Below target at sealing |
| Leak test | Hold under vacuum, watch decay | Slow decay = seal failure |
| Thermal imaging | Infrared scan after hot fill | Hot band = vacuum loss |
What to do with the data
Set an acceptance threshold in the purchase order — for example, minimum temperature after 6 hours under a defined protocol — and test a random sample from each production lot. This turns an unverifiable claim into a pass/fail criterion.
Related: vacuum flasks, 40oz tumbler.
---